- Additional information
- Technical Data Sheet
- Color Shades
Capital Chemical Industries Wall Filling is a product for filling blemishes, cracks, and holes on masonry surfaces and patching up surface imperfections on plastered walls, wood, hardboard, and chipboard. It is specially formulated for leveling minor surface irregularities and provides a key to facilitating the adhesion of the top coat
- Excellent whiteness
- Durable and high performance
- High quality filling properties
- Quick drying and good coverage
Drummy (20Kg), Gallon (5Kg)
Ensure that the surface is fully dry & free from powdery material for maximum adhesion. This can be achieved by rubbing with abrasive paper followed by the removal of loose dust with solvent-soaked cloth. When completely dry apply one coat of Saver Series Wall Filling and let it dry for 24 hours. It will completely fill all the pores and holes in the surface and will make it non-permeable for moisture thereby helps in achieving better coverage and surface finishing.
Apply Saver Series Wall Filling with the scraper. Apply 2-3 coats as required and let it dry for 8 hours. Once dried apply , Saver Series Weather Power, or Saver Series Plus Emulsion. Please note that use of the Filler on the Exterior surface is not recommended use a Plaster / Cement mix for removing surface defects.
Tips For Safety, Economy and Environmental Protection
Keep the paint container airtight after use and store it in a shady & dry place. Rinse with plenty of water in case of eye contact and seek medical advice. Use skin cleanser to remove splashes from the skin. Scrape excess paint out of brushes and rollers before cleaning. Wash all equipment immediately after using water. Do not dispose-off excess paint or paint waste into drains or watercourses disposal should be done in accordance with the environmental regulations.
|Main Uses||Used as a filling coat on walls, ceilings, and all other masonry surfaces before applying Saver Series Plus Emulsion, Weather Power, or Value Emulsion.|
|Covering Capacity||5-6 m²/Kg per application|
|Application||Brush or Roller|
|Drying Time||Surface Dry: 12 Hours, Recoat ability 18 hours|